Clock and time setting function
1）To set up the device time: Press the SET button once and time indicator will start
flashing, then press ▲ button to select the hour and press SET. Press ▲ once
again to set the minute.
2）Once you have set the device time, press SET once again (ON indicator will be
shown on the left side of the display) to set the time when you want the machine to
start making ice on schedule.
3）After you set the time press SET once again (OFF indicator will be shown on the left
side of the screen) to set the time when you want the machine to STOP making ice.
NOTE: You are only able to set this schedule within 24 hours. There is no calendar for
future dates. Once schedule is over, you can set another schedule even on the
same day.
VIII. Self-cleaning mode
The self-cleaning mode should be put into operation before you use your ice maker for the
first time and/or if there has been a long period without use.
Three icons as large, medium and small icons will be on at the same time when the ice
maker is in self-cleaning mode.
Stage 1:
1) Add equal amount of water and vinegar (1:1) into water reservoir.
2) In the state of stand-by mode, keep pressing ON/OFF button at least 5 seconds
to activate self-cleaning mode. Please note self-cleaning mode will automatically start
after “Beep” sound.
3) During the self-cleaning mode, pump will draw water to the ice making box and
evaporator coils, then ice making box rotates and pours the water into water reservoir.
This cycle will repeat for 5 times.
4) Upon completion, the unit automatically changes to stand-by mode.
Stage 2:
1) Remove the drain cap and plug, then drain off the water, insert the plug and screw drain
cap.
2) Add fresh water to the maximum permit water volume line.
3) In the state of stand-by mode, keep pressing ON/OFF button at least 5 seconds
to activate self-cleaning mode again with the purpose of clean-out.
4) Upon completion of this final stage of the self-cleaning process, the unit automatically
changes to stand-by mode. Proceed to drain the water from the internal reservoir by
removing the drain cap and plug. Leave the upper lid open to allow it to air dry.
To Next Page
Loading...