40-150cm.
22
4-12 Installation of Support leg
Notice: when the Support leg touches
the car surface, the Support leg
indicator must be all green (as shown
in the figure22)
Notice:
1.Take the Support leg out from the storage
bin at the bottom of the base
2.Press the expansion button to pull the
support leg out
3.Place child in car seat and secure with
5-point seat belt system
1.Check and tighten ISOFIX attachment, Support leg and 5-point seat
belt system to ensure seat and child are firmly fixed.
2.The 5-point seat belt should not be twisted or wound.
3.When installing the car seat by rearward facing and children’s
height is less than 75cm, it must use new born cushion.
4.We recommend to install car seat with ISOFIX attachment guider .
5.The seat must be as close to (against) the back of the vehicle seat as
possible
6.The child restraint system should not be installed in the position
where the airbag is installed in the rearward facing position.
The 100-150cm I-Size Booster seat
cannot use the Support leg.
To Next Page
Loading...