Instruction
Manual
5.Installation method
5-1 Making rearward facing position by using ISOFIX attachment+
Support leg (suitable for children height from40-105cm)
1.When installing the child safety seat in the
forward facing position, take the Support leg
out from the bottom of the seat according to
method 4-10, and then rotate the seat to the
rearward position according to method 4-6
Installing the ISOFIX attachment to the car seat
Warning: This child car seat must not be used in a vehicle seat
where airbag has been activated.
2.Press the supporting leg adjustment
button by your hand and pull the Support
leg down until it touches the car surface
3.Place the child in car seat and secure
with 5-point seat belt system
Attention: When the supporting leg
touches the car surface, the support
leg indicator must be all green
(as shown in the figure).
Attention! If your child’s height is less than 105cm,
pls use rearward facing.
25
26
To Next Page
Loading...