EVOLUTION 6000 series Truck Mounted Charger
14
Maintenance
MSA
US
(1) Disassemble the charger system.
(2) Remove the six retaining screws on the rear casing panel. Remove rear panel.
(3) Remove the feed cable with the Phoenix connector at the top right of the PCB.
(4) Remove the blown fuse with non-conductive plastic tweezers and replace with a new fuse.
(5) Reconnect the feed cable with the Phoenix connector.
(6) Carefully slide the printed circuit board back in place. Ensure that the spare battery charger
LEDs are aligned properly over the light tubes for proper indication.
(7) Position the rear panel and secure with the six retaining screws.
(8) Restore power to the charger system.
Technical Data
Dimensions Width
Height without camera
Height with camera
Depth
6 inches (150 mm)
3.14 inches (80 mm)
7.87 inches (200 mm)
9.25 inches (235 mm)
Permitted temperature range for fault-free
charging
5°C to 45°C
Nominal voltage 10 V to 36 VDC
Nominal input current < 2.0 A DC
Normal battery charging time 3.5 hours per battery
To Next Page
Loading...
