INSPECTING SCREWS ON THE CLEARCOMMAND BRACKET
5. With one hand inside the
facepiece firmly press the
component housing and
cover together until they
lock.
a. Install the Phillips head
screws and tighten.
6. Install the drinking tube coupling.
a. Lubricate the barb
with Snoop, P/N
600920.
b. Insert the coupling
into the external
drinking tube ½”.
c. Stow the external
drinking tube
coupling.
NOTE: To reduce snag hazards, stow the tube under the
flange.
7. Use a Phillips screwdriver
to install the component
housing ring screw.
MSA will supply screws at no charge. Order screws by contact-
ing customer service at 1 877-672-3473.
Please provide MSA with the number of screw replacment kits
(2 screws per kit; 2 screws per facepiece) and a physical
address (for US Postal Service delivery).
3
MSA 136 (L) Rev. 0 - 10149429
To Next Page
Loading...
