USING THE AIR MASK
25
TAL 1705 (L) Rev. 18 - 10082858
ACTION
VISIBLE/AUDIBLE INDICATOR
V
ISIBLE INDICATOR,
without Thermal Alarm with Thermal Alarm CONTROL MODULE
automatic activation with
the system pressurized
manual activation
sensing mode (with or
without pressure
pre-alarm with
or without
pressure
full alarm (with or without
pressure)
deactivation
of full alarm
deactivation of pre-alarm
(with shake or move unit)
low battery
thermal alarm activation
(see thermal alarm activa-
tion curve)
radio link with
base station*
evacuation signal received*
redundant alarm (cylinder
pressure is below 25% of
rated service pressure
single rising tone with bee-
bop
start-up single rising tone
with bee-bop (also full
alarm)
none
low volume, low urgency
medium volume,
medium urgency
high volume, high urgency
full volume, high urgency
with a buzz
Bee
none
1 beep every 5 seconds
N/A
none
none
continuous beep beep
none
single rising tone with bee-
bop
start-up single rising tone
with bee-bop (also full
alarm)
none
low volume, low urgency
medium volume,
medium urgency
high volume, high urgency
full volume high urgency
with a buzz
Bee
none
1 beep every 5 seconds
1 beep every 3 seconds
none
none
continuous beep beep
none
green/red LED flash front
panel
green/red LED flash front
panel - red light flashing
green LED flashed
red LED flashes
red LED flashes
red LED flashes
green LED flashes
green LED flashes
empty battery icon on dis-
play
flashing thermometer icon
on display
radio link indicator icon in
upper left corner of display
radio link indicator icon dis-
appears
flashing “running man” icon
appears on display
red LED flashes
first 4 sec-
onds
(approx.)
second 4
seconds
(approx.)
last 4 sec-
onds
(approx.)
first push
of reset
button
second
push of
reset button
link is
established
out of
range
*Action only available when the FireHawk M7 Telemetry Module is used.
Chart 3: Audible/Visible Indicators, FireHawk M7 Power Module (integrated PASS version)
metal plate on the front edge of the bracket.
2
. Rotate the FireHawk M7 HUD so that the tab falls into
the slot behind the thumbscrew.
3
. Thread the thumbscrew into the tab to finger-tight.
DO NOT use a screwdriver to tighten the thumbscrew.
To Next Page
Loading...
