EasyManuals Logo

MSA Ultima Series Quick Start Guide

MSA Ultima Series
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
GB
Order No.: 10083027/00
Calibrator
The Calibrator operation is very simple, by three-buttons to
perfom:
a zero function,
a zero and span calibration and
displaying and changing the multiplex address of the
Gas Monitor.
Controller
The Controller allows the following operations to be performed
on an ULTIMA/ULTIMA X Gas Monitor:
Set Monitor time and date
Set the average interval
Set/display span gas value
Set/display alarms
Display minimum, maximum, and average gas readings
Enable calibration Output Signal
Configure auto-calibration feature
Display previous calibration date
Set/display address
Mimic Calibrator
Set or display Range (ULTIMA X Series units only).
For detailed information please refer to the
ULTIMA/ULTIMA X
Controller and Calibrator Manual.

Other manuals for MSA Ultima Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MSA Ultima Series and is the answer not in the manual?

MSA Ultima Series Specifications

General IconGeneral
DisplayLCD with backlight
Communication PortsRS-485, Modbus RTU
Measurement RangeDepends on sensor connected
AccuracyDepends on sensor connected
Outputsrelays
CertificationsUL

Related product manuals