AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
Programmable Delay Controller
PN 7560
WARNING: During installation, disconnect the battery cables. When Disconnecting, always
remove the Negative cable first and install it last.
Parts Included:
1 – Delay Controller 8 – #10 Screws 10 – Butt Splices
1 – Pro-Data+ Disk 4 – #10 Nuts 2 – Ring Terminals
1 – 9-Pin Harness, 10-Feet 4 – #10 Washers
2 – Deutsch Terminated Harnesses 1 – 1-Pin Harness
Figure 1 Hand Held Programmer, PN 7550.
The optional Hand Held Programmer/Monitor, PN 7550,
connects through the 9-pin connector on the Control and
features an LCD display that allows you to walk through
the controller menus as well as monitor the engine’s rpm,
the current switch cycle, alerts and more (Figure 1).
There is also a computer disk supplied with the MSD Pro-
Data+ software. This software is for PC’s running windows
95, 98, NT, 2000 or ME. All of the adjustable parameters
can be reviewed and set then uploaded to the Controller.
The MSD Programmable Delay Controller allows you to
program up to five delay time periods for five output
switches. Programming the delay timer and other
options can be done with the MSD PN 7550 Hand held
Monitor or with the MSD Pro-Data software on a PC with
Windows operating system.
Note: Solid core spark plug wires cannot be used with this controller.
To Next Page
Need help?
General
