Chapter 3
3-16
Note: You need to install a modem/LAN card supporting power on
function for Wake Up On Ring/LAN function.
Note: If you change these settings, you must reboot the system until it
enters the operating system and then power off the system. By doing
so, the changed settings will come into effect next time when you
power on the system.
Power Button Function
This feature sets the function of the power button. Settings are:
On/Off The power button functions as normal on/off button.
Suspend When you press the power button, the computer enters
the suspend/sleep mode, but if the button is pressed for
more than four seconds, the computer is turned off.
Wake Up On Ring/LAN
When setting to Enabled, the features allow your system to be awakened from
the power saving modes through an incoming call from the modem or any
incoming signal received via the LAN. Settings: Enabled and Disabled.
Wake Up On PME
When setting to Enabled, the feature allows your system to be awakened from
the power saving modes through any event on PME (Power Management
Event). Settings: Enabled and Disabled.
Resume By RTC Alarm
This is used to enable or disable the feature of booting up the system on a
scheduled time/date from the soft off (S5) state. Settings: Enabled and Disabled.
RTC Alarm Date/Hour/Minute/Second
If Resume By RTC Alarm is set to Enabled, the system will automatically
resume (boot up) on a specific date/hour/minute/second specified in these
fields. Available settings for each item are:
Alarm Date 01 ~ 31, Every Day
Alarm Hour 00 ~ 23
Alarm Minute 00 ~ 59
Alarm Second 00 ~ 59
To Next Page
Loading...
