8
Fan Power Connectors: CPUFAN1/SYSFAN1
The 4-pin CPUFAN1 (processor fan) and 3-pin SYSFAN1 (system
fan) support system cooling fan with +12V. CPUFAN1 can support
three- or four-pin head connector. When connecting the wire to
the connectors, always take note that the red wire is the positive and should be connected to the
+12V, the black wire is Ground and should be connected to GND. If the mainboard has a System
Hardware Monitor chipset on-board, you must use a specially designed fan with speed sensor to
take advantage of the CPU fan control.
MSI Reminds You...
Always consult the vendors for proper CPU cooling fan.
Front Panel Connectors: JFP1/JFP2
The mainboard provides two front panel connectors for
electrical connection to the front panel switches and LEDs.
JFP1 is compliant with Intel Front Panel I/O Connectivity
Design Guide.
Front Panel Audio Connector: JAUD1
The front panel audio connector allows you to connect
to the front panel audio and is compliant with Intel ®
Front Panel I/O Connectivity Design Guide.
MSI Reminds You...
If you do not want to connect to the front audio header, pins 5 & 6, 9 & 10 have to be
jumpered in order to have signal output directed to the rear audio ports. Otherwise, the
Line-Out connector on the back panel will not function.
Front USB Connector: USB1/USB2
The mainboard provides two standard USB 2.0 pin headers
USB1&USB2. USB2.0 technology increases data transfer rate
up to a maximum throughput of 480Mbps, which is 40 times
faster than USB 1.1, and is ideal for connecting high-speed
USB interface peripherals such as USB HDD, digital cameras,
MP3 players, printers, modems and the like.
MSI Reminds You...
Please note that the pins of VCC & GND must be connected correctly, or it may cause some
damage
To Next Page
Loading...
