2-19
Hardware Setup
Chassis Intrusion Switch Connector: JC1
This connector is connected to a 2-pin chassis switch. If the chassis is opened,
the switch will be short. The system will record this status and show a warning
message on the screen. To clear the warning, you must enter the BIOS utility and
clear the record.
Wake On LAN Connector: WOL
This connector allows you to connect to a LAN card with Wake On LAN
function. You can wake up the computer via remote control through a local area
network.
WOL
5VSB
GND
MP_WAKEUP
1
Pin Definition
PIN SIGNAL PIN SIGNAL
1 LCLK 2 Key (no pin)
3 LRST# 4 VCC3
5 LAD0 6 FID0_LRST
7 LAD1 8 VCC5
9 LAD2 10 Key (no pin)
11 LAD3 12 GND
13 LFRAME# 14 GND
FWH/LPC Debugging Pin Header: JLPC1
The pin header is for internal debugging only.
JLPC1
13
14
2
1
JC1
1
2
CINTRU
GND
MSI Reminds You...
To be able to use this function, you need a power supply that provides
enough power for this feature. (750 mA 5V Stand-by)
To Next Page
