3-19
BIOS Setup
***On-Chip Serial ATA Setting***
OnChip Serial ATA Mode
[Disabled] Select this if you want to disable both SATA controller.
[Combined] You can use the IDE, S-ATA and P-ATA devices, and maximum
of 2 devices in each channel are supported (maxinum of 4
devices). Refer to the table below for the combination.
[Enhanced] Enable both S-ATA and P-ATA devices, and maximum of 6
devices are supported (maxinum of 4 SATA devices).
[Auto] Let the system arrange automatically.
[SATA Only] SATA is operating in legacy mode.
PATA IDE Mode/SATA Port
This Item allows you to set the parallel IDE and the SATA port operation mode.
Setting options: [Primary], [Secondary].
On-Chip Serial ATA
(Combined)
SATA Only [SATA 1/3/2/4]
PATA Pri, SATA Sec [IDE1, SATA2/4]
SATA Pri, PATA Sec [SATA1/3, IDE1]
PATA Only [IDE1]
To Next Page
Loading...
