2-7
Hardware Setup
Memory
The mainboard provides two 240-pin non-ECC DIMMs and supports dual-channel
technology up to 2GB system memory.
For more information on compatible components, please visit http://www.msi.com.tw/
program/products/mainboard/mbd/pro_mbd_trp_list.php
DDRII
240-pin, 1.8V
Dual-Channel: Channel A in GREEN; Channel B in ORANGE
Dual-Channel Memory Population Rules
Dual-Channel mode can enhance the performance of the system. Please refer to the
following illustration for population rules under Dual-Channel mode.
64x2=128 pin56x2=112 pin
DIMM1
DIMM2
Important
-DDRII modules are not interchangeable with DDR and the DDR2 standard is
not backwards compatible. You should always install DDR2 memory mod-
ules in the DDR2 DIMM slots.
-In dual-channel mode, make sure that you install memory modules of the
same type and density in differentchannel DDR DIMM slots.
-To enable successful system boot-up, always insert the memory modules
into the DIMM1 first.
- Due to the chipset resource deployment, the system density will only be
detected up to 1+GB (not full 2GB) when each DIMM is installed with a 1GB
memory module.
To Next Page
Loading...
