42
BIOS Setup
fSerial (COM) Port x Settings [Auto]
Sets serial port x (COM). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.
f Hardware Monitor
Sets fan speeds. Press <Enter> to enter the sub-menu.
fCPU/ SYS FanX Smart Fan Control [Enabled]
Enables or disables the smart fan control. Smart Fan Control automatically
controls fan speed depending on target temperature and to keep it with a specific
operating speed. When the temperature is over the maximum temperature, the
fan will operate maximum speed. When the temperature is under the minimum
temperature, the fan will operate minimum speed.
fCPU/ SYS FanX fan type select [PWM Mode/ DC Mode]
Sets PWM mode or DC mode for installed CPU/ system fan.
fCPU/ SYS FanX level 1~4 Temperature [40, 55, 70, 85]
Sets target temperature for level 1 to 4 (low to high). The fan will operate designate
speed according to level 1~4 target temperatures. These items will be un-available
when Smart Fan Control is disabled.
fCPU/ SYS FanX level 1~4 Fan Speed [13, 38, 63, 100]
Sets fan duty cycle (%) for level 1 to 4 (low to high). The fan will operate designate
duty cycle according to level 1~4 target temperatures. These items will be un-
available when Smart Fan Control is disabled.
fCPU/ SYS FanX step up/ down time
Allows you to set the period of fan step up/ down.
fCPU Fan Fail Warning Control [Disabled]
Enables or disables to show the CPU fan fail warning message on the POST.
fCPU temperature Warning Control [Disabled]
Enables or disables to show the CPU hight temperature warning message.
f Power Management Setup
Sets system Power Management of ErP and AC Power Loss behaviors. Press Enter to
enter the sub-menu.
fErP Ready [Disabled]
Enables or disables the system power consumption according to ErP regulation.
[Enabled] Optimize the system power consumption according to ErP
regulation. It will not support S4 & S5 wake up by USB, PCI and PCIe
devices.
[Disabled] Disables this function.
To Next Page
Loading...
