MSI B250M BAZOOKA

41
BIOS Setup
▶Serial (COM) Port x Settings [Auto]
Sets serial port x (COM). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.
▶Parallel (LPT) Port Configuration
Sets detailed con󰘰guration of parallel port (LPT). Press <Enter> to enter the sub-
menu.
▶Parallel (LPT) Port [Enabled]
Enables or disables parallel(LPT) port.
▶Parallel (LPT) Port Settings [Auto]
Sets parallel port (LPT). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.
▶Device Mode [STD Printer Mode]
Selects an operating mode for parallel port.
[STD Printer Mode] Printer port mode
[SPP] Standard Parallel Port mode
[EPP-1.9/ 1.7 + SPP] Enhanced Parallel Port-1.9/ 1.7 mode + Standard
Parallel Port mode.
[ECP] Extended Capability Port mode
[ECP + EPP-1.9/ 1.7] Extended Capability Port mode + Enhanced Parallel
Port-1.9/ 1.7 mode.
▶Hardware Monitor
Sets fan speeds. Press <Enter> to enter the sub-menu.
▶CPU/ SYS FanX Smart Fan Control [Enabled]
Enables or disables the smart fan control. Smart Fan Control automatically
controls fan speed depending on target temperature and to keep it with a speci󰘰c
operating speed. When the temperature is over the maximum temperature, the
fan will operate maximum speed. When the temperature is under the minimum
temperature, the fan will operate minimum speed.
▶CPU/ SYS FanX fan type select [PWM Mode/ DC Mode]
Sets PWM mode or DC mode for installed CPU/ system fan.
▶CPU/ SYS FanX level 1~4 Temperature [40, 55, 70, 85]
Sets target temperature for level 1 to 4 (low to high). The fan will operate designate
speed according to level 1~4 target temperatures. These items will be un-available
when Smart Fan Control is disabled.
▶CPU/ SYS FanX level 1~4 Fan Speed [13, 38, 63, 100]
Sets fan duty cycle (%) for level 1 to 4 (low to high). The fan will operate designate
duty cycle according to level 1~4 target temperatures. These items will be un-
available when Smart Fan Control is disabled.
▶CPU Fan Fail Warning Control [Disabled]
Enables or disables to show the CPU fan fail warning message on the POST.