En-30
MS-7793 Manboard
tRAS
Determnes the tme RAS (row address strobe) takes to read from and wrte to mem
-
ory cell.
tRTP
Ths tem s used to adjust the tme nterval between a read and a precharge com
-
mand.
tRC
The row cycle tme determnes the mnmum number of clock cycles a memory row
takes to complete a full cycle, from row actvaton up to the prechargng of the actve
row.
tWR
Mnmum tme nterval between end of wrte data burst and the start of a precharge
command. Allows sense amplers to restore data to cells.
tRRD
Speces the actve-to-actve delay of derent banks.
tWTR
Mnmum tme nterval between the end of wrte data burst and the start of a
columnread command. It allows I/O gatng to overdrve sense amplers before read
command starts.
tRFC0/ 1
These settngs determne the tme RFC0/1 takes to read from and wrte to a memory
cell.
Advanced Channel 1/ 2 Tmng Conguraton
Press <Enter> to enter the sub-menu. And you can set the advanced memory tmng
for each channel.
DgtALL Power
Press <Enter> to enter the sub-menu.
CPU Core Vdroop Oset Control
Ths tem s used to select the CPU core Vdroop oset control mode.
CPU NB Vdroop Oset Control
Ths tem s used to select the CPU-NB Vdroop oset control mode.
CPU Core OCP Expander
Ths tem s used to expand the lmtaton of CPU core OCP (Over Current Protec
-
ton). The hgher expandng value ndcates less CPU protecton. So please adjust
the CPU core voltage carefully f needed.
CPU NB Core OCP Expander
Ths tem s used to expand the lmtaton of CPU-NB OCP (Over Current Protecton).
The hgher expandng value ndcates less CPU-NB protecton. So please adjust the
CPU-NB voltage carefully f needed.
CPU Core Swtchng Frequency
Ths tem allows you to ncrease PWM workng speed to stablze CPU core voltage
and mnmze rpple range.
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶