MSI G41TM-S01 Series

Hardware Setup ▍
MS-7602
2-13
Hardware Setup ▍
MS-7602
Fan Power Connectors: CPUFAN1, SYSFAN1
The fan power connectors support system coolng fan wth +12V. When connectng the
wre to the connectors, always note that the red wre s the postve and should be con-
nected to the +12V; the black wre s Ground and should be connected to GND. If the
manboard has a System Hardware Montor chpset on-board, you must use a specally
desgned fan wth speed sensor to take advantage of the CPU fan control.
1
.
G
r
o
u
n
d
2
.
+
1
2
V
3
.
S
e
n
s
o
r
4
.
C
o
n
t
r
o
l
1
.
G
r
o
u
n
d
2
.
+
1
2
V
3
.
S
e
n
s
o
r
CPUFAN1 SYSFAN1
Important
Please refer to the recommended CPU fans at processor’s o󰘲cal webste or consult
the vendors for proper CPU coolng fan.
CPUFAN1 supports fan control. You can nstall
Overclockng Center utlty that wll
automatcally control the CPU fan speed accordng to the actual CPU temperature.
Fan cooler set wth 3 or 4 pns power connector are both avalable for CPUFAN1.
SYSFAN1 support fan control, too. You may select how percentage of speed for the
SYSFAN1 n BIOS.
Chasss Intruson Connector: JCI1
Ths connector connects to the chasss ntruson swtch cable. If the chasss s opened,
the chasss ntruson mechansm wll be actvated. The system wll record ths status
and show a warnng message on the screen. To clear the warnng, you must enter the
BIOS utlty and clear the record.
1
.
C
I
N
T
R
U
2
.
G
r
o
u
n
d
•
•
•
•