MSI H61MU-E35 series - Page 46

3-10
BIOS Setup
MS-7680
Chapter 3
BIOS Setup
MS-7680
Chapter 3
EuP 2013
Ths tem s desgned for energy usng products lot 6 2013 (EuP) aka energy related
products (ErP); to reduce power consumpton durng system o󰘯 or standby mode.
Note: Enablng EuP 2013 wll dsable support for RTC Wake Up Event.
Restore on AC Power Loss
Ths tem spec󰘰es whether your system wll reboot after a power falure or nterrupt
occurs. Settngs are:
[Power O󰘯] Always leaves the computer n the power o󰘯 state.
[Power On] Always leaves the computer n the power on state.
[Last State] Restore the system to the status before power falure or nterrupt
occurred.
Wake Up Event Setup
Press <Enter> to enter the sub-menu.
Wake Up Event By
Settng to [BIOS] actvates the followng 󰘰elds, and use the followng 󰘰elds to set the
wake up events. Settng to [OS], the wake up events wll be de󰘰ned by OS.
Resume By RTC Alarm
The 󰘰eld s used to enable or dsable the feature of bootng up the system on a
scheduled tme/date.
Date/ HH:MM:SS
If Resume By RTC Alarm s set to [Enabled], the system wll automatcally resume
(boot up) on a spec󰘰c date/hour/mnute/second spec󰘰ed n these 󰘰elds (usng the
<+> and <-> to select the date & tme settngs).
Resume By PCI or PCI-E Devce
When set to [Enabled], the feature allows your system to be awakened from the
power savng modes through any event on PCI or PCIE devce.
Resume From S3 by USB Devce
The tem allows the actvty of the USB devce to wake up the system from S3 (Sus
-
pend to RAM) sleep state.
Resume From S3 by PS/2 Mouse/ KB
These tems determne whether the system wll be awakened from S3 state when
nput sgnal of the PS/2 mouse/ keyboard s detected.
▶
▶
▶
▶
▶
▶
▶
▶
▶