Hardware Setup
E-2-17
Serial ATA RAID Connectors controlled by nForce2 RAID MCP:
SATA1/SATA2
The Southbridge of this mainboard is nForce2 RAID MCP which supports two
serial ATA connectors SATA1 and SATA2.
SATA1 and SATA2 are dual high-speed Serial ATA interface ports. Each sup-
ports 1
st
generation serial ATA data rates of 150 MB/s. Both connectors are fully
compliant with Serial ATA 1.0 specifications. Each Serial ATA connector can connect
to 1 hard disk device.
PIN SIGNAL PIN SIGNAL
1 GND 2 TXP
3 TXN 4 GND
5 RXN 6 RXP
7 GND
SATA1/SATA2 Pin Definition
MSI Reminds You...
Please do not fold the serial ATA cable in a 90-degree angle, which will
cause the loss of data during the transmission.
Connect to serial ATA ports
Take out the dust cover and
connect to the hard disk
devices
Serial ATA cable
7
1
SATA1
SATA2
1
7
To Next Page
Loading...
