BIOS Setup
3-7
IDE Primary Master/Slave, SATA1/2/3/4
Device, Vender, Size
These settings show the IDE/SATA device information. Read only.
LBA/Large Mode
This setting allows you to enable or disable the LBA Mode. Setting to [Auto]
enables LBA mode if the device supports it and has not been formatted with LBA
mode disabled.
DMA Mode
This setting specifies the DMA Mode.
Hard Disk S.M.A.R.T.
This setting allows you to activate the S.M.A.R.T. (Self-Monitoring Analysis &
Reporting Technology) capability for the hard disk drives. S.M.A.R.T is a utility
that monitors your disk status to predict hard disk failure. This gives you an
opportunity to move data from a hard disk that is going to fail to a safe place
before the hard disk becomes off-line.
Floppy Drive A
This setting allows you to set the type of floppy drives installed.
Important
The IDE Primary Master/Slave, SATA1/2/3/4 items appear when you con-
nect hard disk drives to the IDE/SATA connector on the mainboard.
To Next Page
Loading...
