CHAPTER 3 AWARD
®
BIOS SETUP
3-20
V/H SYNC=Blank
Blank Screen
DPMS
This selection will cause the system to turn off the
vertical and horizontal synchronization ports and write
blanks to the video buffer.
This option only writes blanks to the video buffer.
Select this option if your monitor supports the Display
Power Management Signaling (DPMS) standard of the
Video Electronics Standards to select video power
management values.
Video Off Method
This determines the manner in which the monitor blanked.
MODEM Use IRQ
This determines the IRQ in which the MODEM can use.
The choices: 3, 4, 5, 7, 9, 10, 11, NA.
Soft-Off by PWR-BTTN
The settings are Delay 4 sec or Instant-off. During Delay 4 sec, if
you push the switch once, the system goes into suspend mode. If you push
it more than 4 seconds, the system will be turned off. During instant-off, the
system will turn off once you push the switch.
Video Off After
The settings are N/A, Standby, Doze, or Suspend. This option is for
choosing the setting in which the monitor will turn off.
N/A Always turn on.
Doze During Doze mode, the monitor will be turned off.
Standby During Standby mode, the monitor will be turned
off.
Suspend During Suspend mode, the monitor will be turned
off.
The default setting is Standby.
To Next Page
Loading...
