3-9
BIOS Setup
Full Screen LOGO Display
This item enables you to show the company logo on the bootup screen. Settings are:
[Enabled] Shows a still image (logo) on the full screen at boot.
[Disabled] Shows the POST messages at boot.
Boot Sequence
Press <Enter> to enter the sub-menu:
1st/2nd/3rd Boot Device
The items allow you to set the sequence of boot devices where BIOS attempts to
load the disk operating system.
Boot from Other Device
Setting the option to [YES] allows the system to try to boot from other device if the
system fails to boot from the 1st/2nd/3rd boot device.
Optical Drive AAM
Use this field to configure the AAM (Automatic Acoustic Management) mode.
Important
Available settings for “1st/2nd/3rd Boot Device” vary depending
on the bootable devices you have installed.
To Next Page
Loading...
