MS-7329 Mainboard
2-8
Important Notification about Power Issue
nForce chipset is very sensitive to ESD (Electrostatic Discharge), therefore this issue
mostly happens while the users intensively swap memory modules under S5 (power-
off) states, and the power code is plugged while installing modules. Due to several
pins are very sensitive to ESD, so this kind of memory-replacement actions might
cause system chipset unable to boot. Please follow the following solution to avoid
this situation. Unplug the AC power cable (shown in figure 1) or unplug the JPWR1 &
JPW1 power connectors (shown in figure 2 & figure 3) before the 1st installation or
during system upgrade procedure.
Figure 1:
Unplug the AC power cable
Figure 2:
Unplug the JPWR1 power conn.
Figure 3:
Unplug the JPW1 power conn.
To Next Page
Loading...
