3-17
BIOS Setup
Power Button Function
This feature allows users to configure the Power Button function. Settings are:
[On/Off] The power button functions as a normal power-on/-off
button.
[Suspend] When you press the power button, the computer enters
the suspend/sleep mode, but if the button is pressed for
more than four seconds, the computer is turned off.
Restore on AC Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
[Power Off] Leaves the computer in the power off state.
[Power On] Leaves the computer in the power on state.
[Last State] Restores the system to the previous status before power
failure or interrupt occurred.
Wakeup Event Setup
Press <Enter> to enter the sub-menu:
Resume By PCI Device (PME#)
When setting to [Enabled], this setting allows your system to be awakened
from the power saving modes through any event on PME (Power Management
Event).
Resume By PCIE Device
When setting to [Enabled], this setting allows your system to be awakened
from the power saving modes through any event on PME (Power Management
Event). Setting options: [Disabled], [Enabled].
Resume by RTC Alarm
This is used to enable or disable the feature of booting up the system on a
scheduled time/date from the S3, S4, and S5 state.
To Next Page
Loading...
