3-14
MS-7380 Mainboard
Re-Call VGA BIOS From S3
When ACPI Standby State is set to [S3], users can select the options in this field.
Selecting [Yes] allows BIOS to call VGABIOS to initialize the VGA card when system
wakes up (resumes) from S3 sleep state. The system resume time is shortened
when you disable the function, but system will need an VGA driver to initialize the
VGA card. Therefore, if the VGA driver of the card does not support the initialization
feature, the display may work abnormally or not function after resuming from S3.
Soft-Off by PWR BTTN
This feature allows users to configure the power button function. Settings are:
[Instant-Off] The power button functions as a normal power-on/-
off button.
[Suspend] When you press the power button, the computer
enters the suspend/sleep mode.
Restore On AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt
occurs. Settings are:
[Off] Always leaves the computer in the power off state.
[On] Always leaves the computer in the power on state.
[Last State] Restores the system to the status before power failure
or interrupt occurred.
Wake Up Event Setup
Press <Enter> and the following sub-menu appears.
Resume From S3 By USB Device
The item allows the activity of the USB device to wake up the system from S3
(Suspend to RAM) sleep state.
Resume by PCI Device (PME#)
W hen setting to [Enabled], this setting allows your system to be awakened from
the power saving modes through any event on PME (Power Management Event).
Resume By PCI-E Device
To Next Page
Loading...
