To Previous Page

A-4

Troubleshooting

The power LED is o󰓐.

■ Press the monitor power button again.

■ Check if the monitor power cable is properly connected.

No image.

■ Check if the computer graphics card is properly installed.

■ Check if the computer and monitor are connected to electrical outlets and

are turned on.

■ Check if the monitor signal cable is properly connected.

■ The computer may be in Standby mode. Press any key to activate the

monitor.

The screen image is not properly sized or centered.

Refer to Preset Display Modes to set the computer to a setting suitable for the

monitor to display.

No Plug & Play.

■ Check if the monitor power cable is properly connected.

■ Check if the monitor signal cable is properly connected.

■ Check if the computer and graphics card are Plug & Play compatible.

The icons, font or screen are fuzzy, blurry or have color problems.

■ Avoid using any video extension cables.

■ Adjust brightness and contrast.

■ Adjust RGB color or tune color temperature.

■ Check if the monitor signal cable is properly connected.

■ Check for bent pins on the signal cable connector.

The monitor starts 󰄉ickering or shows waves.

■ Change the refresh rate to match the capabilities of your monitor.

■ Update your graphics card drivers.

■ Keep the monitor away from electrical devices that may cause

electromagnetic interference (EMI).

Questions and Answers:

Need help?

Do you have a question about the MSI Oculux NXG251R and is the answer not in the manual?

MSI Oculux NXG251R Specifications

General