MSI Z77 MPower series - Page 33

1-21
MS-7751
Chapter 1
Boot up the computer and nstall the drvers and software ncluded n your vdeo
card package. For more nformaton, please refer to the manual that came wth your
vdeo card.
After all of the hardware and software has been properly nstalled, reboot the
system. After enterng the operatng system (OS), rght clck on the desktop and
choose the “Catalyst Control Center”.
3.
4.
The CrossFre™ settng must be enabled to allow CrossFre™ mode to operate.
The follow screen appears n the Catalyst Control Center. Dependng on your
operatng system, the screen may look d󰘯erent.
5.
Important
A CrossFre
TM
system has four possble dsplay modes:
SuperTlng
Scssor Mode
Alternate Frame Renderng
Super Ant-alasng.
For more detals, please consult the graphcs card manual.
•
•
•
•