13
7.8 Turn on the Heater on the controller, refer to the “Controller operation” section. Maximum heating
temperature is 40°C(104°F). Hourly heating rate is about 1.5°C-2°C(2.5°F-3.5°F) for 4 persons and
1.2°C-1.8°C(2°F-3°F) for 6 persons.
7
7.7
7.6
Lock Unlock
7. Water Filling
7.1 Ensure the spa liner is at the selected area and point the
drain valve toward a suitable draining area before filing
water. Make sure the drain valve is securely tightened.
7.2 Fill the spa tub with fresh water to a level between
Minimum and Maximum line marked on the inside of the
spa wall.
Do not over fill the spa. It is recommended to fill the spa with lukewarm water for quick heating and energy
saving.
WARNING:
● Water level must reach the Minimum water line but not exceed the Maximum line to avoid pump
failure.
● Never pour water with a temperature higher than
40°C(104°F) into the spa directly.
● To avoid control system failure, do not operate the spa until
water reaches the Minimum line.
7.3 Check the connecting tubes and make sure there is no water
seeping. Assemble the “U” shape cover.
7.4 Install the filter cartridge. Please refer to the instruction on P17.
7.5 Insert the inflatable bladder into the buckled cover. (Keep valve
and printing towards outside)
7.6 Inflate the bladder with the hand pump.
7.7 Place the cover over the spa tub and insert the buckle to the
base that attached on the spa tub.
7.3
Lock the Buckle
● Insert the buckle on the Spa tub into the Spa cover
buckle, until you hear a “Click” sound.
Unlock the Buckle
● Pinch both sides of the locked buckle, and press
down the round dot in center in the same time. Press
down the center button and release the lock.
To Next Page
Loading...
Need help?
General
