PROBLEM CAUSE SOLUTION
NO DISPLAY ON THE
CONTROL PANEL
SPA LEAKING
NOT HEATING
PROPERLY
Change a socket or repair the socket before use
Reset the PRCD by following the PRCD Testing section
Contact local MSpa Service Center
Contact local MSpa Service Center
Tighten the in&outlet connection
Close the drainage valve. Contact the MSpa Service Center,
if spa is still leaking
Repair the leaking hole/split with the repair kit material
Set a higher temperature
Clean or replace the filter cartridge
Add more water to the minimum line
Contact local MSpa Service Center
Refer to the "FILTER PUMP DOES NOT WORK" section
Reset the heater
Power socket failure
PRCD is off
Press the Reset button, controller is not displayed
PRCD broken
Spa in&outlet connection not securely tight
Drainage valve is not closed completely
Water leaks from the spa pool body
Temperature set too low
Dirty filter cartridge
Water level is not at the minimum water line
Heater failure
Filter pump DOES NOT WORK
Temperature protection switch trip off
16
SPA LOSES AIR
WATER NOT CLEAN
SPA TUB IN AN
ABNORMAL SHAPE
BUBBLE AIR BLOWER
DOES NOT WORK
FILTER PUMP DOES
NOT WORK
Inflate the spa till Yellow section of the manometer is pushed out.
Make sure the valve is screwed tightly. Replace the valve if necessary.
Fill a squirt bottle with soapy water and spray on the seams.
If there is a leak, small bubbles will come out. When you have located
the leak, clean and dry the leaking area, then use the repair patch supplied
with your spa. Check the repair section on P13.
Change the water
Extend the filtration time
Clean or replace the filter cartridge in time
Refer to the chemical manufacturer’s instructions
Check the air pressure and release air if necessary
During hot weather, it is advisable to check whether some air should be
released to avoid any possible damage to the spa pool.
Wait for 10 minutes and turn on the Bubble button again
Contact local MSpa Service Center
Turn the knob to <OFF> position and turn on the bubble button again.
Clean or replace the filter cartridge
Contact local MSpa Service Center
Air valve is loose
Hole or split on the spa tub
Water has been used for long
period of time
Insufficient filtering time
Dirty filter cartridge
Improper water maintenance
Extra air pressure due to strong sunlight
Auto-off 10 minutes
Internal parts damaged
Inflation knob is in <ON> position
Filter cartridge clogged by dirt or
other objects
Filter system failure
To Next Page
Loading...
Need help?
General
