mspa D-AU04 Aurora User Manual

98 pages

To Next Page

To Previous Page

REF. NO. PARTS DESCRIPTION QTY.

Spa cover with aluminum foil inside

(Square shaped spa comes with a ground mat with the cover)

Spa tub

Wired controller

Digital lock (for D-NE02, D-SC04/06, D-AU04/06, D-CA04/06)

Filter cartridge

Spa drain valve adaptor

Repair kit

Wrench

Wicker side bar (Only for Nest D-NE02)

Buckle spa cover and ground mat set (For D-AL04/06, D-TE06, D-LA06)

Instruction DVD

NOTE: When ordering parts, be sure to quote the model number and part numbers.

FIRST USE AND SET-UP PREPARATION

The spa can be installed indoor and outdoor around 10 minutes by at least one person. For household use

only. For household use only.

The spa must be set up on a flat, smooth and supporting surface that is capable of supporting the

maximum load of the filled spa with listed maximum occupants.

Make sure the area is free of sharp objects under or around the spa. Uneven of unsound surfaces can

damage the spa and void your warranty. Level the surface before filling spa with water.

Provide adequate drainage system around the spa to deal with overflow water and splashes.

Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance

and/or service.

●

Site preparation and requirements

Verify the supporting floor can support the filled weight of spa with maximum number of occupants. Check

with a qualified contractor or structural engineer to verify the requirement.

Make sure the floor is water resistant and provides non-slip surface. Do not install the spa on a carpet of

any other material that could damaged by the moisture.

Humidity is a naturally side effect of indoor spa installation. The room shall be properly ventilated to allow

moisture to escape. Install a ventilating system to prevent excess condensation moisture in the room.

●

Additional requirements for indoor installation

Questions and Answers: