mspa D-AU04 Aurora - Troubleshooting; No Display on the Control Panel; Spa Leaking; Not Heating Properly

21
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
NO DISPLAY ON
THE CONTROL
PANEL
Power failure
PRCD is off
PRCD broken
Check power source
Reset PRCD
Contact the MSpa Service Center
NOT HEATING
PROPERLY
Temperature set too low
Heating element failed
Set a higher temperature
Contact the MSpa Service Center
Add more water to the minimum line
BUBBLE AIR
BLOWER DOES
NOT WORK
Bubble motor failure
Auto-off 10 minute
Contact the MSpa Service Center
SPA LEAKING
Spa inlet/outlet connection not
securely tight
Tighten the inlet and outlet
connection
Water leaks from the spa
pool body
Water level is not at the
minimum water line
Waiting for 10 minutes and turn on the
Bubble button again
Drainage valve is not closed
completely
Contact the MSpa Service Center, if spa is
still leaking
Repair the leaking hole/spilt with the repair
kit material