2019-2020
Delight Service Manual
Visit our website at: www.the-mspa.com
- 37 -
Filter pump doesn't work Refer to filter pump doesn't work section
Bubble air
blower does
not work
Inflation knob is in "ON"
position, not turned to "OFF"
Turn the Knob to "OFF" position and turn on the bubble button again.
Auto-off 10 minutes after it
works every 20 mins
It's normal that the spa is programed to
Auto-off 10 minutes after it works every 20 mins
Wait for 10 mins to restart the bubble
Bubble fails to inflatable
Take out the control box (heater/blower engine) to the local service
partner a new power board & bubble generator needs to be replaced.
Video guide: https://youtu.be/lhOkbOFGgWk
Bubble function doesn't work
while all other functions works
Take out the control box (heater/blower engine) to the local service
partner a new bubble generator needs to be replaced.
Video guide: https://youtu.be/lhOkbOFGgWk
Filter pump
does not work
Power failure Check power supply
Low water level Add more water to reach the minimum water line.
Filter cartridge stuck by dirt or
other objects
Replace with a new filter and clean the inlet.
Video guide: https://youtu.be/4-jyyfKg9xM
Spa tub
deformation
No liquid chlorine for water
sanitizing.
Bromine is highly recommended for good water quality. No liquid
chlorine for water sanitizing.
Over-inflation or extra air
pressure under strong
sunshine
Release the air till the manometer shows yellow.
Well-covered with a MSpa overall cover when leaving spa outside.No
direct exposure under strong sunshine.
Spa looses
air
Air valve got loosen Screw up tight the air valve
Hole or puncture on the spa
tub
Re-glue help or contact service partner to replace a new pool body:
https://youtu.be/szF-4t0Ff5Q
Water not
clean
Insufficient filtering time Extend the filtering time
Dirty filter cartridge Clean or replace a new filter cartridge
Improper water maintenance
Use proper chemicals
(HTH brand is recommended)
To Previous Page
Loading...
Need help?
General
