12
SPA SET-UP
Move the entire package to the selected site. Open the carton carefully as it can be used to store the spa
during long term storage or when not in use.
Lay out all the parts on the ground and make sure all parts are accounted for. Make sure the spa tub is
right side up. (*For missing or damaged part, contact the MSpa Service Center)
1.
2.
1 2
Nest M-001LS: For this model, a side bar is
included in the package. Set up the wicker bar and
place the supporting legs underneath the spa tub
before filling the water. It helps keeping the oval
spa in a proper shape after water filling and
inflation.
●
Alpine M-009LS/019LS:
Spread out the square
ground mat and place it to
the selected site. Make
sure the buckle of cover
and mat is attached when
spa not in use.
●
NOTE:
The heat preservation ground mat is not for the MSpa LITE except for Alpine M-009LS/019LS. It is
recommended to apply a ground mat for the spa tub to prevent scratches or heat loss.
NOTE:
this side
face down
Spa Control Unit Connected
External Equipotential Bonding
Conductors
A qualified electrician shall wire the spa control
unit to the household equipotential terminal using
a minimum 1.5mm² solid copper conductor as
follow.
To Next Page
Loading...
Need help?
General