14
5.6 When inflation is completed. Press Bubble button again to turn it off. Disconnect the inflation
hose on both ends. Replace the air valve cap back.
NOTE:
● The cap is designed to be screwed on and off. Never exert force as this could cause the complete
internal inflation system of the valve to come loose.
● If over inflated, remove the inflation hose from the spa air valve side, screw the valve cap to
release some air and stop until the manometer points to the right color section.
5.4
5.5
Green
Yellow
Over Inflation
Red
Button
(a)
Water Filling
6.1 Check the spa liner is at the selected area and point
the drain valve toward a suitable draining area before
inflation.
6.2 Fill the spa tub with fresh water to a level between
Minimum and Maximum line marked on the
inside of the spa wall.
Do not over fill the spa. It is recommended to fill the spa with lukewarm water for quick heating and
energy saving.
WARNING:
● Water level must reach the Minimum water line but not exceed the Maximum line to avoid
pump failure.
● Never pour water with a temperature higher than 40°C(104°F) into the spa directly.
● To avoid control system failure, do not operate the spa until water reaches the Minimum
line.
6.3 After water filling, double check the spa pool air pressure to make sure the manometer points out the
Green section.
6.4 Place the zipper spa cover over the spa tub, and make sure the spa cover zipper are closed and lock
the cover by the digital lock in the accessory pack.
IMPORTANT:
● Inspect the spa pressure regularly for leak, premature wear or deterioration.
● Check and wax the zipper regularly, to make it smooth for operation and avoid splits.
6.
6
NOTE: Deflation Instruction
Spa Deflation
1. Unscrew the air valve cap on the spa pool to deflate the spa.
2. Once the deflation is completed, replace the cap back.
To Next Page
Loading...
