Why is my mspa Super Camaro M-051S not heating properly?
If your MSpa Hot Tub isn't heating properly, start by setting a higher temperature. If the display shows SPL/SPH, or you suspect a heater failure, contact the MSpa Service Center.
Why is my MSpa Hot Tub losing air pressure?
If your MSpa Hot Tub is losing air pressure, ensure the air valves are secure; if loose, tighten or replace them. If the tub has a hole or split, apply soapy water to the seams to locate the leak (it will bubble). Clean and dry the area, then use the provided repair patch to seal it.
What to do if the filter pump does not work on my mspa Super Camaro M-051S Hot Tub?
If the filter pump on your MSpa Hot Tub isn't working, first, check the power source. If the power is fine, and you suspect a filter system short circuit or that the filter is stuck, contact the MSpa Service Center.
Why does the bubble air blower not work on my mspa Super Camaro M-051S Hot Tub?
If the bubble air blower on your MSpa Hot Tub isn't working, and you suspect a bubble filter short circuit, contact the MSpa Service Center. Note that the blower may auto-off after 10 minutes; wait for 10 minutes before restarting.
What to do if there is no display on my MSpa Hot Tub control panel?
If your MSpa Hot Tub control panel shows no display, first check the power supply to ensure it's working. If the power is on, check if the RCD (Residual Current Device) is off and reset it. If the RCD is broken or the pin plug connection has failed, contact the MSpa Service Center.
What to do if my mspa Super Camaro M-051S is leaking water?
If your MSpa Hot Tub is leaking water, first ensure that the spa inlet/outlet connections are securely tightened. If the leak persists, and it's coming from the drainage valve, contact the MSpa Service Center. If the water leaks from the spa pool body, repair the leaking hole/split with the repair kit material.
Why is my mspa Super Camaro M-051S in an abnormal shape?
If your MSpa Hot Tub is in an abnormal shape, it might be due to extra air pressure from strong sunshine. Check the air pressure and release some air if necessary. During hot weather, it is recommended to check if it is necessary to release some air to avoid any possible damage to the spa pool.
What to do if my mspa Super Camaro M-051S Hot Tub is leaking?
If your MSpa Hot Tub is leaking, it is recommended to contact the MSpa Service Center for assistance.
What to do if the bubble air blower does not work on my MSpa Hot Tub?
If the bubble air blower on your MSpa Hot Tub does not work, it is recommended to contact the MSpa Service Center.
How to fix no display on the control panel of my mspa Super Camaro M-051S Hot Tub?
If there is no display on the control panel of your MSpa Hot Tub, ensure all internal connections are well connected.
Critical safety warnings regarding drowning and electrical hazards, requiring extreme caution.
Important safety instructions related to electric shock, proper connections, and child supervision.
General precautions for operating the spa, including handling chemicals and avoiding damage.
Guidelines for selecting and preparing the installation site for optimal safety and performance.
Instructions for testing the Residual Current Device for electrical safety before use.
Initial steps for unpacking, positioning the spa liner, and preparing the base.
Instructions for inflating the main spa tub using the air blower and manometer.
Guidance on filling the spa with water, including temperature and level recommendations.
General| Model | Super Camaro M-051S |
|---|---|
| Pump | 1.5 HP |
| Heater | 1500W |
| Massage Air Blower | 720W |
| Type | Inflatable |
| Capacity | 6 People |
| Water Capacity | 245 gallons |
| Temperature Range | 68-104°F |
| Material | 6-layer Reinforced PVC |
| Air Jets | 138 |
To Next Page