To Next PageTo Next PageWhy is my mspa Carlton M-CA062 not heating properly?
Your MSpa Hot Tub might not be heating properly due to several reasons. The temperature may be set too low, so try setting a higher temperature. A dirty filter cartridge can also cause heating issues, so clean or replace it. Ensure the water level is at least at the minimum line; if not, add more water.
What to do if my mspa Carlton M-CA062 is leaking?
If your MSpa Hot Tub is leaking, first check the spa in&outlet connection and tighten it securely. Also, ensure the drainage valve is completely closed. If water leaks from the spa pool body, repair the leaking hole or split using the repair kit material.
How to fix a mspa Hot Tub that loses air?
If your MSpa Hot Tub is losing air, start by checking if the air valve is loose. Inflate the spa until the yellow section of the manometer is pushed out, and make sure the valve is screwed tightly. If necessary, replace the valve. Also, check for any holes or splits on the spa tub. You can use soapy water to locate leaks, then clean and dry the area before applying the repair patch.
What to do if there is no display on the mspa Carlton M-CA062 Hot Tub control panel?
If there is no display on the control panel of your MSpa Hot Tub, the power socket may have failed; change or repair the socket. Also, the PRCD might be off; reset it by following the PRCD Testing section.
General| Model | M-CA062 |
|---|---|
| Type | Inflatable Hot Tub |
| Heat Increasing Rate | 2-3°F per hour |
| Cabinet Color | Brown |
| Control System | Digital |
| Filtration System | Cartridge |
| Material | PVC |
| Cover | Insulated Cover |
| Capacity | 6 people |
Critical safety alerts regarding drowning, injury, and electric shock hazards.
Important safety guidelines covering electrical connections, child safety, and proper installation.
Details on shape, seating, capacity, dimensions, weight, and temp rate for Carlton and Otium.
Specs for control system, power, heater, blower, pump, ozone, jets, UVC, lid, and liner.
Guidelines for selecting and preparing a suitable location for spa installation.
Instructions for testing the Portable Residual Current Device (PRCD) for electrical safety before use.
Procedures for filling the spa with water, including warnings and temperature recommendations.
Best practices for water changes, chemical use, and maintaining water balance for health.
Table listing error codes, their causes, and solutions for diagnosing spa issues.
