To Next PageTo Next PageWhy is my MSpa Hot Tub not heating properly?
If your MSpa Hot Tub isn't heating properly, start by setting a higher temperature. If the display shows SPL/SPH, or you suspect a heater failure, contact the MSpa Service Center.
Why is my mspa Mont Blanc P-MB06 Hot Tub losing air pressure?
If your MSpa Hot Tub is losing air pressure, ensure the air valves are secure; if loose, tighten or replace them. If the tub has a hole or split, apply soapy water to the seams to locate the leak (it will bubble). Clean and dry the area, then use the provided repair patch to seal it.
What to do if the filter pump does not work on my MSpa Hot Tub?
If the filter pump on your MSpa Hot Tub isn't working, first, check the power source. If the power is fine, and you suspect a filter system short circuit or that the filter is stuck, contact the MSpa Service Center.
Why does the bubble air blower not work on my MSpa Hot Tub?
If the bubble air blower on your MSpa Hot Tub isn't working, and you suspect a bubble filter short circuit, contact the MSpa Service Center. Note that the blower may auto-off after 10 minutes; wait for 10 minutes before restarting.
What to do if there is no display on my MSpa Hot Tub control panel?
If your MSpa Hot Tub control panel shows no display, first check the power supply to ensure it's working. If the power is on, check if the RCD (Residual Current Device) is off and reset it. If the RCD is broken or the pin plug connection has failed, contact the MSpa Service Center.
What to do if my mspa Mont Blanc P-MB06 is leaking water?
If your MSpa Hot Tub is leaking water, first ensure that the spa inlet/outlet connections are securely tightened. If the leak persists, and it's coming from the drainage valve, contact the MSpa Service Center. If the water leaks from the spa pool body, repair the leaking hole/split with the repair kit material.
Why is my mspa Mont Blanc P-MB06 in an abnormal shape?
If your MSpa Hot Tub is in an abnormal shape, it might be due to extra air pressure from strong sunshine. Check the air pressure and release some air if necessary. During hot weather, it is recommended to check if it is necessary to release some air to avoid any possible damage to the spa pool.
Critical safety warnings for drowning, injury, and electric shock hazards.
Electrical safety, appliance placement, and RCD usage guidelines.
Covers electrical connections, children's supervision, floor support, and water temperature.
Addresses hyperthermia, alcohol use, and medical conditions.
Lists and illustrates all items included in the product package.
Guidelines for selecting a suitable location and preparing the installation site.
Specific considerations for installing the spa indoors.
Guidelines for setting up the spa outdoors.
Procedure for testing the Residual Current Device for safety.
Steps for moving, laying out parts, ground mat, and control panel connection.
Detailed steps for inflating the spa tub using the manometer.
Guide for changing the digital lock password.
Instructions on how to lock and unlock the spa cover buckle.
Importance of regular cleaning and sanitizing for water quality.
Procedures for maintaining water quality and cleaning filter cartridges.
How to inspect, clean, and replace the filter cartridge.
Maintaining correct pH, alkalinity, and chlorine levels.
Step-by-step guide to draining water from the spa.
Instructions for cleaning the spa tub after draining.
Guide for repairing punctures in the spa tub or air bladder.
General