Warning
For your safety, it is important that you read the entire
owner's manual and its warnings.
Warnings
Do not ride around without having rst fastened your helmet
carefully.
Do not clean your helmet with petroleum-based products, sol-
vents, benzene, thinners or abrasive cleaners.
Do not paint over the nish of your helmet without protecting
and insulating the EPS and plastic parts, otherwise your war-
ranty will be void.
Do not drop your helmet from any height onto a hard surface.
This could cause damage to the nish of your helmet and/or
decrease its ability to protect it.
Do not place your helmet in the rearview mirror of your motor-
cycle: the strong pressure from the edge of the mirror will com-
press and damage the helmet's EPS liner.
Do not place your helmet on the motorcycle seat or in the fuel
tank. It could easily roll off and hit the ground causing irrepara-
ble damages. It is best to place the helmet on a at surface or,
alternatively, on the ground so that it cannot roll or fall.
Do not use your helmet if the visor is scratched. This can affect
your vision, especially when riding at night.
Do not modify any part of your helmet, do not drill into the shell,
or cut or press on the EPS liner. Installation of sound systems,
speakers and microphones reduces the ability of your helmet to
protect you and is not recommended.
Do not reuse your helmet if it has been dropped or damaged
in an accident. Replace it even if the damage is not visible to
the naked eye.
Do not wear dark or tinted visors in dark or poorly visible riding
conditions.
Do not put the interiors or pads in the dryer after washing. Allow
to air dry.
Do not attempt to remove, change or replace the visor while
riding your motorcycle.
Do not use paint that requires heat drying.
30
WARNINGS
To Next Page
Loading...
