MTA TAEevo121 - Page 43

40
MAINTENANCE AND OPERATING MANUAL
Chapter 11 - Setting tables
The data inside this manual are not binding and they can be modified by the manufacturer without notice. All rights reserved.
TAEevo015÷351
11.1.3 Dymanic set point parameters (NBCP1OT ENABLED FUNCTION)
11.1.4 Energy Saving parameters (NOT ENABLED FUNCTION)
11.1.5 Compressor parameters
11.1.6 Fan parameters
11.1.7 Antifreeze support resistance parameters
11.1.8 Defrost parameters (NOT ENABLED FUNCTION)
11.1.9 Alarm parameters
11.1.10LASER parameters (NOT ENABLED FUNCTION)
CF44 U Default bottom displaying of remote terminal:
•0 = BEWOT.
•1 = BTWOT.
• 2 = none.
•3 = BAT1.
• 4 = unit setpoint
• 5 = unit status (**)
•6 = Laser set
• 7 = none
• 8 = operating differential
06 4
Pr2 Password 0 999 -
Parameter Level Description Min. Max. Udm Resolution Factory setting
Pr2 Password 0 999 -
Parameter Level Description Min. Max. Udm Resolution Factory setting
Pr2 Password 0 999 -
Parameter Level Description Min. Max. Udm Resolution Factory setting
EVAPORATOR UNLOADING
CONDENSER UNLOADING
Pr2 Password 000 999 -
Parameter Level Description Min. Max. Udm Resolution Factory setting
HOT START
Pr2 Password 000 999 -
Parameter Level Description Min. Max. Udm Resolution Factory setting
Ar03 U Antifreeze alarm set Ar01 Ar02 °C
°F
Dec
Int
3°C
38°F
BOILER FUNCTION (NOT ENABLED)
Pr2 Password 000 999 -
Parameter Level Description Min. Max. Udm Resolution Factory setting
Pr2 Password 000 999 -
Parameter Level Description Min. Max. Udm Resolution Factory setting
Pr2 Password 000 999 -
Parameter Level Description Min. Max. Udm Resolution Factory setting
Pr2 Password 000 999 -
Parameter Level Description Min. Max. Udm Resolution Factory setting