MTA TAEevo121 - SETTING TABLES; 11.1 Parameter setting; 11.1.1 Thermoregulation parameters; 11.1.2 Configuration parameters

TAEevo015÷351
39
MAINTENANCE AND OPERATING MANUAL
Chapter 11 - Setting tables
The data inside this manual are not binding and they can be modified by the manufacturer without notice. All rights reserved.
TAEevo015÷351
C HAPTER 11
S ETTING TABLES
The following tables show the list of all masks which contain adjustable parameters.
On Factory setting column are indicated the setting values set during the unit testing; they are referred only to the unit which has the same serial
number you can find on the label of the first page of this manual.
DANGER
The wrong programming of the electronic control could cause big damages to the unit.
The parameters can be modified by specialized personnel only.
11.1 Parameter setting
To modify the following parameters, follow the procedure illustrated in Chapter 7 “Access to “Pr1” parameters (User level)“ and Chapter 7
“How to modify a parameter’s value“.
11.1.1 Thermoregulation parameters
11.1.2 Configuration parameters
Parameter Level Description Min. Max. Udm Resolution Factory setting
ST01 U Summer set point ST05 ST06 °C
°F
°C
°F
Dec
Int
9°C with 1 compr.
48°F with 1compr.
8°C with 2 compr.
47°F with 2compr.
ST02 U Summer differential 00.0
00.0
25.0
45.0
°C
°F
°C
°F
Dec
Int
4°C with 1 compr.
7°F with 1 compr.
2°C with 2 compr.
4°F with 2 compr.
ST05 U Summer min. set -40.0
-40.0
ST01 °C
°F
Dec
Int
5.0°C
41°F
Pr2 Password 0 999 - -
Parameter Level Description Min. Max. Udm Resolution Factory setting
CF34 U Serial address 1 247 1
CF36 U Default top displaying:
•0 = BEWIT.
•1 = BEWOT.
• 2 = none.
•3 = BAT1.
• 4 = unit setpoint
• 5 = unit status (**)
• 6 = Laser set
• 7 = none
• 8 = operating differential
08 1
CF42 U Default bottom displaying:
•0 = BEWOT.
•1 = BTWOT.
•2 = BCP1
•3 = BAT1.
• 4 = unit setpoint
• 5 = unit status (**)
• 6 = Laser set
• 7 = none
• 8 = operating differential
08 4
CF43 U Default top displaying of remote terminal:
•0 = BEWOT.
•1 = BTWOT.
•2 = BCP1
•3 = BAT1.
• 4 = unit setpoint
• 5 = unit status (**)
• 6 = Laser set
• 7 = none
• 8 = operating differential
08 1