Operation
5
16
Bagger Usage
NOTE: When both grass bags are full, place the tractor on a firm,
level surface, disengage the PTO, turn the tractor engine off and
set the parking brake.
1. Open the grass catcher hood by pushing in on the rear,
right-side tab with your right hand, as seen in 1 of Figure
5-1, and lifting the cover with your left hand in the center
rear of the bagger cover, 2.
Figure 5-1
2. Do not remove the chute tube assembly from the tractor.
3. Remove the grass bags by lifting these up (1) and moving
the bags away from the bag support assembly (2). See
Figure 5-2.
Figure 5-2
4. Empty the grass clippings at a proper disposal site, use the
handle at the bottom of each grass bag. Holding the bag
firmly, empty the contents
5. Replace grass bags, close lid, flip down seat, restart your
tractor, release parking brake and resume cutting your
grass.
To Next Page
Loading...
