Need help?Do you have a question about the MTD 213-430-000 and is the answer not in the manual?
Controls engine speed and stops the engine.
Selects transmission modes: NEUTRAL, REVERSE, or FORWARD.
Engages wheel and tine drive mechanisms when squeezed against handle.
Adjusts the tilling depth of the tiller.
Allows side-to-side and height adjustment of the handle.
Steps to perform before operating the tiller, including engine service and fuel.
Procedure for starting the engine, including choke and gear selection.
Guides on setting depth bar, side shields, and operating modes for effective tilling.
How to adjust the handle position and height for operator comfort.
Periodic adjustment for belt tension due to wear, affecting tiller performance.
Warnings and guidance on adjusting the carburetor, recommending factory settings.
Instructions for engine maintenance, including oil, air cleaner, and spark plug.
To Next Page
General