MTD 27-Ton - User Manual

Questions and Answers

M
Melissa WilsonAug 6, 2025
What to do if the cylinder rod will not move on my MTD 27-Ton?
- L
  Larry HammondAug 7, 2025
  If the cylinder rod on your MTD Log Splitter isn't moving, there could be several reasons. Start by checking if the shipping plugs were left in the hydraulic hoses; if so, disconnect the hoses, remove the plugs, and reconnect them. Also, verify the oil level is correct. The hydraulic lines or control valve might be blocked, in which case you should flush and clean the hydraulic system. Ensure that the shaft coupling isn't loose and correct the engine/pump alignment if necessary.
H
Heidi GonzalezAug 11, 2025
Why is my MTD 27-Ton Log Splitter cylinder leaking?
- P
  Paul WeberAug 11, 2025
  A leaking cylinder in your MTD Log Splitter could be due to worn seals or a scored cylinder.
N
Nicolas MayAug 15, 2025
Why is my MTD Log Splitter wood splitting so slowly?
- C
  Courtney GoodmanAug 15, 2025
  If your MTD Log Splitter is splitting wood slowly, several factors could be the cause. It might be due to a damaged small gear section, a leaking pump check valve, or excessive pump inlet vacuum. Check the oil level and make sure it's correct. Contaminated oil can also cause this issue; if so, drain the oil, clean the reservoir, and refill. Avoid attempting to split wood against the grain, as an overloaded cylinder can also be the reason.
J
Joseph GravesAug 21, 2025
Why is the cylinder shaft speed slow on my MTD Log Splitter?
- C
  Calvin AndersonAug 21, 2025
  If your MTD Log Splitter has a slow cylinder shaft speed while extending and retracting, the oil level might be incorrect, so check it. Also, contaminated oil can cause this, so drain the oil, clean the reservoir, and refill. Make sure the pump inlet hoses are clear and unblocked.
R
Ryan BrownAug 26, 2025
Why is the pump shaft seal leaking on my MTD 27-Ton?
- A
  Angela DuncanAug 26, 2025
  If the pump shaft seal on your MTD Log Splitter is leaking, the engine/pump might be misaligned; correct the alignment as necessary. Also, a plugged oil breather can cause this issue, so ensure the reservoir is properly vented.
G
Gabriel RoweAug 31, 2025
What to do if the control handle does not return to neutral on my MTD 27-Ton?
- W
  william08Aug 31, 2025
  If the control handle on your MTD Log Splitter doesn't return to neutral when released from the forward position, the hydraulic fluid might be too cold, so warm up the engine. Alternatively, the hydraulic fluid could be too thick or contaminated, in which case you should replace it.