7.
8.
Push forward on the variable speed pulley, lift
the belt off the engine pulley, and remove the
belt from the pulley.
Release the clutch-brake pedal Using the pedal
to move the variable speed pulley as necessary,
lift the belt up and off the variable speed pulley.
NOTE: When reassembling, make certain belt is
inside the pins. See Figure 24.
l/Variable
Speed Pulley
. __ ,dl
Figure 29
9. Reassemble with a new belt, following
instructions in reverse order.
10. Adjust the speed control as instructed in
adjustment section.
SECTION 11: OFF-SEASON
STORAGE
If the machine is to be inoperative for a period longer
than 30 days, prepare for storage as follows.
1. Clean the engine and the entire unit thoroughly.
2. Lubricate all lubrication points. Wipe the entire
machine with an oiled rag to protect the
surfaces.
3_
4.
5.
6.
Refer to the engine manual for correct engine
storage instructions. The engine must be
completely drained of fuel to prevent gum
deposits from forming on essential carburetor
parts, fuel lines and fuel tanks.
Charge battery fully. The battery loses some of
its charge each day when the unit is not used.
NEVER store battery without a full charge.
Recharge battery before returning to service or
every two months, whichever occurs first.
When storing unit for extended periods,
disconnect battery cables. Removing battery
from unit is recommended.
Store unit in a clean, dry area. Do not store next
to corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment
in an unventilated or metal storage shed, care
should be taken to rustproof the equipment. Using a
light oil or silicone, coat the equipment, especially
any chains, springs, bearings and cables.
23
To Next Page
Loading...
Need help?
General
