MTD 700 Series - Page 7

7Section 2 — ASSembly & Set-Up
1. Remove wing nut (a) and hex
screw (b) from chute control head and
clevis pin (c) and cotter pin (d) from
chute support bracket. Position chute
assembly (forward-facing) over chute
base. See Figure 2-7.
(a)
(b)
(c)
(d)
Chute
Control Head
Chute
Chute
Support
Bracket
Chute
Base
Figure 2-7
2. Place chute assembly onto chute base
and secure chute control head to chute
support bracket with clevis pin (c) and
cotter pin (d) removed in Step 1.
See Figure 2-8.
(c)
(d)
Figure 2-8
3. Finish securing chute control head to
chute support bracket with wing
nut (a) and hex screw (b) removed in
Step 1. See Figure 2-9.
(b)
(a)
Figure 2-9
4. Insert chute control rod into the support
bracket on rear of the dash panel.
See Figure 2-10.
Figure 2-10
5. Remove hairpin clip (a) from rear of
chute control head. See Figure 2-11.
6. Insert chute control rod (b) into rear
of chute control head. See Figure 2-11.
Secure chute control rod to chute
control assembly with hairpin clip (a)
removed in Step 5.
(a)
(b)
Figure 2-11
STOP
STOP! Continue to Set-Up
(page 12).
Overhead Chute Control (with Chute Control Rod)
Figure 2-6