Insert 10' of 0.080" SplitLine
®
through
hole in top of reel. Pull most of line
through hole until 3-4" remains.
Wind line tightly in direction of arrow.
Split other end of SplitLine
®
back 6-7".
Push 6-7" ends into
0.080" holding slots.
Insert lines through eyelets in spool.
Insert spring and reel into spool.
Pull lines firmly to release
from holding slots.
Hold the inner reel in place.
Tighten Bump Knob clockwise.
Bend short end and push it
into the other hole. Pull tight.
Bump
Knob
Inner
Reel
Spool
Spring
Press primer bulb 10 times.
Put choke lever in
Position 1.
Move choke lever to
Position 2.
Move choke lever
to Position 3.
SQUEEZE and HOLD throttle
control for ALL further steps.
Pull the rope
5 times.
Pull the rope until engine
starts. Run engine for 30
to 60 seconds to warm up.
Continue squeezing the
throttle control and run engine
for additional 60 seconds to
complete warm up.
Crouch in starting
position.
DIDN’T START?
Repeat these instructions.
If engine still fails to start, refer
to Starting Instructions or
Troubleshooting for
additional starting
information.
Quick Instructions to
Replace SplitLine
®
Trimmer Line
Replacement SplitLine
®
Part #49U2134K953
For single line installation,
see page 4.
For replacement spool
installation, see page 4.
Quick Instructions
to Start Engine
for complete instructions see page 3.
Quick Instructions to
Assemble Curved
Shaft or Straight
Shaft String
Trimmers
for complete instructions
see page 3.
OR
Unscrew Bump Knob™
counterclockwise.Remove
inner reel and spring.
Grip
6"
5 X
IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING THE UNIT.
1 Gallon 3.2 oz
40:1
Slot
Bracket
Put handle on shaft so that it
tips toward engine. Move handle
6 inches away from shaft grip.
Insert bolt. Tighten washer and
wing nut onto bolt.
Slide the shield’s slot onto the mounting bracket. Rotate
the shield onto the shaft. Push square bolt through shield
and bracket. Tighten washer and wing nut onto bolt.
Slide the shield onto the shield mount.
Place hex lock nuts into the 3 holes.
Insert screws from the bottom. Tighten.
Mix thoroughly in a separate fuel can:
– 3.2 oz of 2-cycle engine oil
– 1 gallon of unleaded gasoline
Place the unit on a level surface. Fill fuel tank.
NOTE: Do not mix directly in the engine fuel tank.
BL100
Curved Shaft
BL150
Straight Shaft
Read and understand all instruction, warning and danger labels on the unit.
LINE
RELOAD
To Next Page
Need help?
General
