C and D series mowers
50
8. Remove the 6 screws that hold the rear baffle to the
mower deck using a T-40 driver or a 9/16” wrench.
See Figure 4.60.
9. Separate the rear baffle assembly from the mower
deck. See Figure 4.61.
10. On installation, confirm that the belt and lower belt
cover are properly positioned as the new rear baffle
goes in. See Figure 4.62.
• The belt must fit inside of all four guide pins in
the lower belt cover.
Figure 4.60
Rear baffle Rear baffle mounting screws
! CAUTION! CAUTION
Wear protective gloves and use cau-
tion when working near the blade.
Figure 4.61
Figure 4.62
Guide pins
To Next Page
Loading...
