To Next PageTo Next Page
Need help?Do you have a question about the MTD C series and is the answer not in the manual?
General| Brand | MTD |
|---|---|
| Model | C series |
| Category | Lawn Mower |
| Language | English |
Safety guidelines for operation and attire, including protective gear and hazard awareness.
Details CAUTION, WARNING, and DANGER signals for hazardous situations.
Warns about hazards and damage caused by operating with bent blades or crankshafts.
Warns that straightening bent blades or crankshafts increases damage and hazard.
Warns that incorrect or improper blade mounting can create a thrown object hazard.
Step-by-step instructions for safely removing the mower blade.
Details safety steps before tipping the mower for service.
Advises caution when removing or tightening the blade bolt due to potential spinning.
Details proper blade installation, orientation, and tightening to specified torque.
Step-by-step guide for sharpening mower blades, including wear determination.
Emphasizes wearing eye protection and keeping guards in place during sharpening.
Warns that poor blade balancing causes vibration and potential injury.
Step-by-step instructions for removing the drive belt from the mower.
Step-by-step guide for installing a new drive belt onto the pulleys.
Steps to check engine RPM, blade stopping time, and cable movement.
Step-by-step procedure for removing and installing the engine control cable.
Steps for removing the drive control housing by folding handlebars and positioning mower.
Instructions for removing screws, separating housing halves, and moving to workbench.
Instructions for reassembling the drive control housing by reversing disassembly steps.
Steps for disconnecting the clutch control cable from the housing and transmission.
Procedure for installing a new drive clutch control cable and testing operation.
Steps for disconnecting the speed control cable from the housing and transmission.
Procedure for installing a new speed control cable and testing operation.
Warns that operating without the trail shield is a safety violation and illegal.
Emphasizes that the side discharge door is a required safety device.
Instructions for removing the side discharge door assembly using a screw.
Steps for clamping, inserting spring, positioning hinge, and securing with hinge pin.
How to position the hinge with alignment bosses and install the securing screw.
Warns that operating without the rear grass door is a safety violation and illegal.
Guide to inspecting the transmission and rear axle for proper operation before removal.
Procedure for removing the transmission and rear axle assembly together.
How to separate the transmission from the axle assembly by releasing spherical bearings.
Advises wearing gloves and caution when working near the blade during baffle removal.
