MTD DUERR 424/LCD/22 User Manual

I
2. Know how to stop the unit and disengage the con :rols.
3. Never place hands or feet between log and splitting wedge or be¬
tween log and end plate during forward or reverse stroke. To do
so may result in crushed or amputated fingers or tot s, or worse,
you may lose an arm or foot.
4. Do not straddle the splitter when using it. A siip in any position
could result in a serious injury.
5. Do not step over your iog splitter when the engine is unning. You
may trip or accidentally activate the splitting wedge if you step
over. If you need to get to the other side, walk arjund.
6. Never try to split two logs on top of each other. Ont may fly out
and injure you.
7. When loading the log splitter, place your hands on tte side of the
log, not at the ends. Never attempt to load your splitter while the
splitting wedge is in motion. You may get caught b/ the wedge
and injured.
8. Only use your hand to operate the splitting wedge or control lever.
Never use your foot or a rope or any other extension device. This
could result in your ability to stop your splitter quickly enough
and cause injury.
9. Always keep fingers away from any cracks that opi n in the log
during splitting operation. They can quickly close <nd pinch or
amputate your fingers.
10. Never attempt to split woods across the grain. Some t'pes of wood
may burst or fly out of your splitter and result in i ijury to you
or a bystander.
11. For logs that are not cut square, the longest porticn of the log
should be rotated down and the most square end pi iced against
the splitting wedge.
12. Keep your work area clean. Immediately remove split wood around
your splitter so that you do not stumble over it. Clean chips and
dirt off end plate (wood platform) after each log is split, or whenever
necessary to maintain flat contact between wood a id end plate
(platform).
13. Never move the log splitter while the engine is rur ning.
14. Never leave your log splitter unattended with the enc ine running.
Shut off the engine if you are leaving your splitter, evi ^n for a short
period of time. Someone could accidentally activate the splitting
wedge and be injured.
15. Do not run engine in an enclosed area. Exhaust gases contain car¬
bon monoxide. This odorless gas can be deadly when inhaled.
16. Be careful not to touch the muffler after the engine has been run¬
ning as it is HOT.
17. If the equipment should start to vibrate abnormally, st ip the engine
and check immediately for the cause. Vibration is geni irally a warn¬
ing of trouble.
18. When cleaning, repairing or inspecting, make certan all moving
parts have stopped. Disconnect the spark plug wire ind keep the
wire away from the plug to prevent accidental sta ting.
MAINTENANCE
1. Do not operate your splitter in poor mechanical condition or when
in need of repair.
2. Periodically check that all nuts, bolts, screws, hose clamps and
hydraulic fittings are tight to be sure equipment is in lafe working
condition. Where appropriate, check all safety guards and shields
to be sure they are in the proper position. Never operae your split¬
ter with safety guards, shields or other protective featu es removed.
These safety devices are for your protection.
3. Replace all damaged or worn parts such as hydraulic hoses and
fittings immediately with manufacturer approved replacement parts.
4. Do not change the engine governor settings or overspeed the,
engine. This increases the hazard of personal injury. The max
imum engine speed is preset by the manufacturer and is within
safety limits.
5. Do not alter your splitter in any manner such as attaching a rope
or extension to the control lever or adding to the width or height
of the wedge. Such alterations may cause your splitter to be unsafe.
6. Perform all recommended maintenance procedures before you use
your splitter.
7. Do not service or repair your log splitter without disconnecting
the spark plug wire.
8. Never store the equipment with gasoline in the tank inside of a
building where ignition sources are present, such as hot water
and space heaters, clothes dryers and the like. Allow the engine
to cool before storing in any enclosure.
9. Always store gasoline in an approved, tightly sealed container.
Store the container in a cool, dry place. Do not store in a building
where ignition sources are present.
10. To reduce fire hazard, keep engine free of grass, leaves, wood
chips, and excessive grease and oil.
11. The hydraulic system of your log splitter requires careful inspec¬
tion, along with the mechanical parts. Be sure to replace frayed,
kinked, or otherwise damaged hydraulic components.
12. Fluid escaping from a very small hole can be almost invisible. Do
not check for leaks with your hand. Escaping fluid under pressure
can have sufficient force to penetrate skin, causing serious per¬
sonal injury. Leaks can be located by passing a piece of card¬
board or wood over the suspected leak and looking for
discoloration.
13. Should it become necessary to loosen or remove any hydraulic,
fitting or line, be sure to relieve all pressure by shutting off the
engine and moving the control handle back and forth several times.
14. Do not remove the cap from the hydraulic tank or reservoir while
your log splitter is running. Hot oil under pressure could cause
injury.
15. The pressure relief valve on your splitter is preset at the factory.
Do not adjust the valve. Only a qualified service technician should
perform this adjustment.
16. Completely drain fuel tank prior to storage. This guards against
accumulation of fuel fumes which could result in a fire hazard.
17. Never store log splitter outside without a waterproof cover. Rain
will cause rust on the inside of the cylinder.
TOWING
1. This unit should not be towed on any street, highway or public
road without checking the existing federal, local or state vehicle
requirements. Any licensing or modifications such as taillights,
etc., needed to comply with the existing federal, local or state
vehicle requirements is the sole responsibility of the purchaser.
2. Before towing, be certain the log splitter is correctly and securely
attached to the towing vehicle, and the safety chains are in place.
Leave slack in chains for turning allowance.
3. Do not allow anyone to sit or ride on your splitter. They can easily
fall off and be seriously injured.
NOTE: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-covered
or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting ^ipplicable local or state laws (if any). If
a spark arrester is used, it shouid be maintained in effect ve working order by the operator.
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar
laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer
or through DUERR INC.
4

MTD DUERR 424/LCD/22 Specifications

General

Brand	MTD
Model	DUERR 424/LCD/22
Category	Log Splitter
Language	English