Need help?Do you have a question about the MTD WCM 84 E and is the answer not in the manual?
General| Cutting Width | 84 cm |
|---|---|
| Engine | Briggs & Stratton |
| Cutting Height Adjustment | 5 positions |
| Engine Type | Single cylinder |
| Starting System | Electric Start |
Appliance approved solely for domestic garden use. Other uses are not intended.
Read instructions before first use, comply with manual and keep for future use.
Provides general safety information. Specific warnings are shown at corresponding points.
Users must not be under the influence of intoxicants or medication.
Never use appliance with damaged or missing safety devices. Must be repaired by technician.
Protects against injuries from thrown objects. Appliance may be operated with flap only.
Wear protective gear, avoid skin contact with battery acid. Consult doctor if swallowed.
Switches cutter deck on/off. Engage by pushing lock forward and holding lever.
Used to start and stop the engine. Key position for starting and stopping.
Switches travel drive on/off. Depress lever and hold to engage.
Keep persons and animals away. Risk of injury from ejected objects.
Keep hands/feet away from rotating parts. Do not work in wet conditions. Risk of slipping.
Run internal combustion engine outdoors only.
Petrol vapours are explosive. Keep away from heat sources. Refuel outdoors.
Do not start in front of ejector. Keep hands/feet away from blade. Disengage clutches.
Always switch off the cutter deck before reversing.
Protect yourself. Switch off engine, remove key, wait for parts to stop.
Check throttle, choke, fuel, spark-plug lead, air filter. Charge battery if applicable.
To Next Page
